Actually not.. Two reasons. First, the drive (/dev/hdd) was added AFTER
Linux was installed, it failed about a month later. Second, after adding
the replacement drive I created a mount point, pointing to the one and only
partition on the drive (/dev/hdd), a fat32 primary partition. I added the
drive info for clarity only.
Thanks glen, that's precisely what I was looking for (etc/fstab).
----- Original Message -----
From: "Russell Hires" <rhires@earthlink.net>
To: <slug@nks.net>
Sent: Saturday, May 05, 2001 10:29 PM
Subject: Re: [SLUG] Re: "My" Dead Hard drive
> Hmmm...well, I think that perhaps your drive is the one that had /etc or
> /usr or /root? Or something important like that? Whether it's primary or
> secondary shouldn't matter. This is also the perfect time to use that
> boot/rescue floppy that's been gathering dust...OTOH, perhaps now is the
> time for the boot CD?
>
> HTH
>
> Russell
>
> -----------------------
> I don't care if you're going nowhere,
> Just take good care of the world.
> -- Depeche Mode
>
> ----------
> >From: Glen Canaday <tuck@acer-access.com>
> >To: slug@nks.net
> >Subject: Re: [SLUG] Re: "My" Dead Hard drive
> >Date: Fri, May 4, 2001, 22:25
> >
>
> > I don't know about using an IDE tape drive, but to 'remove' a partition
only
> > takes editing the drive's lines /etc/fstab out.
> >
> > Glen
> >
> > On Friday 04 May 2001 20:14, you wrote:
> >> Two questions.
> >> 1) I recently had a old hard drive fail (a slave on the secondary ide
> >> channel) that I was only using to learn how to add a w95-fat32 disk,
give
> >> it a mount point and share it via samba. No problem there. However,
the
> >> drive failed. When I removed it. My Linux box would not boot
normally,
> >> but rather to a repair mode. I had to dig out of box a another old
disk,
> >> configure and format a partition. I was unable to configure linux
properly
> >> after the removal of the hard drive. How does one configure linux to
> >> remove a drive.
> >> /dev/hda - HD, Master on primary channel
> >> /dev/hdb - CD, slave on primary channel
> >> /dev/hdc - Tape, Master on secondary channel
> >> /dev/hdd - HD, slave on secondary channel
> >>
> >> 2) I can't seem to utilize this IDE tape drive. What's the process
for
> >> mounting and writing to an IDE tape.
>
This archive was generated by hypermail 2.1.3 : Fri Aug 01 2014 - 16:14:10 EDT