Thanks Mark
I am in the process of following up on your suggestions; that will take a day
or two or maybe even three.
Just completed coping the first How To to paper so I can make notes in it.
After I begand to comprehend the issues I am sure I will have more questions.
Thanks
Frank
On Monday 21 May 2001 01:43 pm, you wrote:
> PCI devices aren't usually PNP. Check to make sure there aren't jumpers
> on the card. Make sure the PCI slot is enabled in the BIOS. Read the
> Modem HOWTO in the LDP. Edit pnp.conf and un-comment out the port
> settings.
Haven't any idea of how to find out which ones yet.
I am working on this.
Make sure you are using the correct device when using your
> dialer.
That I doubt but again I haven't any idea of how to set this.
Need to read and study the How Tos first.
>
> Just a few things to check and get you going without knowing more.
>
<Snip>
>
> ------------------------------------------------------------------------
>
> | Mark Bishop (mark@bish.net) | Computer Engineer |
> | 813.258.2390 | Network Engineer |
> | http://bish.net | Embedded Programmer |
This archive was generated by hypermail 2.1.3 : Fri Aug 01 2014 - 19:22:32 EDT