I have found the best results using netcfg
to configure network cards. At a command line type: netcfg &
This utility will set all the configuration file entries and restart
any services needed. What is the results of the commands:
ifconfig and route ?
Larry :-)
----- Original Message -----
From: Mario Lombardo Sent: Wed, Dec 19, 2001 7:18 PM
Subject: Re: [SLUG] Adding a driver module
> Thanks, Larry, but when I tried it, it didn't work. Why?
> Yet when I do a: modprobe ne io=0x300 irq=10
> it gives a positive status and then I see NE2000 in /proc/interrupts
> and /proc/ioports
> What's going on?
> Mario
>
>
> >In my pc running RH 7.1 with NE2000 nics here is the
> >file: /etc/modules.conf
> >alias eth0 ne
> >options ne io=0x300 irq=10
> >
> >Then you can observe the results with the command dmesg
> >Larry :-)
> >
> >----- Original Message -----
> >From: Mario Lombardo Sent: Sunday, December 16, 2001 5:45 PM
> >Subject: [SLUG] Adding a driver module
> >
> >
> >> Using RedHat 7 out of the box, <snip>
> > > This card uses the NE2000 NIC driver.
> > >
> > > Mario
>
>
> --
This archive was generated by hypermail 2.1.3 : Fri Aug 01 2014 - 20:19:29 EDT