Re: [SLUG] boot time parameters (read-only)

From: Mario Lombardo (mario@alienscience.com)
Date: Wed Jul 24 2002 - 00:45:19 EDT

Next message: Mario Lombardo: "Re: [SLUG] adding a LF to /dev/lp0"
Previous message: Bill: "[SLUG] Apache Error Message"
In reply to: Mario Lombardo: "[SLUG] boot time parameters (read-only)"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

I wasn't clear. "Nothing happens" means it goes straight into RW
mode instead of RO :^)

>I'm running RedHat 7.1 SeaWolf, and I'm trying to get the root
>partition to mount as read-only.
>
>At the LILO prompt I'm entering "linux ro", but nothing happens.
>Has anyone else had this problem? How do I get into read-only
>without trashing my hard disk for it? Would rdev parameters work?
>Whatever is the easiest route. I'd like to run a bad block scan
>again; that's why I want to do this.
>
>Mario

Next message: Mario Lombardo: "Re: [SLUG] adding a LF to /dev/lp0"
Previous message: Bill: "[SLUG] Apache Error Message"
In reply to: Mario Lombardo: "[SLUG] boot time parameters (read-only)"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.3 : Fri Aug 01 2014 - 14:22:07 EDT