Ian,
If I am to set up my second hard drive in the same box with the '98
drive, how do I do that. I am A+ illiterate!! Do I use a ribbon cable
that will accept two devices( the one in there now will only accept one
device.) As I recall from some time ago, they used to have a cable that
had wires switched or something like that for the second device. Do I
need one like that or will a straight two device ribbon cable do the
trick. Do I set the drive as a slave drive on the jumpers, or as a
master as you have suggested?
Michael C. Rock
Systems Analyst
Registered Linux User # 287973
"The time has come the walrus said to speak of many things,,,"
"Christians give up what they cannot keep to gain what they cannot lose"
-----Original Message-----
From: slug@lists.nks.net [mailto:slug@lists.nks.net] On Behalf Of Ian C.
Blenke
Sent: Tuesday, November 26, 2002 6:36 PM
To: slug@nks.net; Mikes work account
Subject: Re: [SLUG] dual boot question
On Tuesday 26 November 2002 15:37, Mikes work account wrote:
> I have a gateway and two hard drives. Each will boot correctly. One
is
> RH 8.0 and the other '98. How do I set up the dual boot with two
drives
> already with systems on them?
Smitty offered a hardware solution. Those have never thrilled me.
The software solution is relatively simple.
1. Make a RH8.0 boot floppy.
- write down your "root" filesystem (like /dev/hda3)
2.Hook up your '98 drive as your primary master. Make sure you can boot
from
it.
3. Hook up your RH8.0 drive as a secondary drive, preferably as the
secondary
master.
4. Boot to the RH8.0 boot floppy, with a "root=/dev/hdc3" parameter (or
merely
replace "hda" with the appropriate block device for your Linux drive).
Also,
use the "single" or "S" option to boot single user, or if you can't seem
to
login or have forgotten the root password, use "init=/bin/bash" to get a
root
shell.
5. Once you have a shell, edit your /etc/fstab and replace all
occurances of
"hda" with the appropriate new block device for your Linux drive).
6. Next, edit your /etc/lilo.conf to boot to "other=dos" on /dev/hda and
then
re-run lilo. Alternatively, you can install grub or your preferred boot
manager (loadlin works from a DOS menu in a pinch).
You can also make a backup of your MBR (first 512 bytes) on the primary
drive
if you want to undo lilo/grub later and make win98 boot as it did
previously.
7. Reboot your system. If you edited your /etc/fstab correctly, the
system
will boot. If not, don't worry, merely reboot with the floppy or get a
"lilo:" (or "grub>") prompt and boot your kernel with the same trick
used in
step 4. Re-edit /etc/fstab and try again.
The keys here are editing your /etc/fstab appropriately, and installing
a
bootloader on your primary master drive (or whatever drive you have your
BIOS
set to boot from).
Hope this clears things up a bit.
-- - Ian C. Blenke <icblenke@nks.net>(This message bound by the following: http://www.nks.net/email_disclaimer.html)
This archive was generated by hypermail 2.1.3 : Fri Aug 01 2014 - 20:12:14 EDT