Richard Smoot wrote:
> I am running SUSE 9.3 Pro with an Epson R200.
> I am using CUPS. I have Epson Inkjet Tools.
> I can normally do clean cycles and nozzle checks within Linux.
>
> Is there any easy way to reset the printer to work again after I let
> it run out of paper before finishing a print job?
> In admin mode I have deleted the unfinshed job. I have turned the power
> off and disconnected power to the printer and put new paper in it.
> After this if I try to print an e-mail, I get a CUPS error.
> I need to be in admin mode to delete the new qued job.
> When I go to control in admin mode it shows the printer ready to print
> a test page. It says it has successfully sent it to the printer. Nothing
> happens. Just another job shows up in Kjobviewer.
> In Epson Inkjet Tools, if I try nozzle check nothing happens-another
> job shows up in Kjobviewer.
> Is there someway of getting it going short of Uninstalling shutting everything
> down to no power and Reinstalling the printer as I have done in the past?
>
> Richard Smoot
>
>
I've got an R200. I have never liked the way it works under Linux. If
I'm doing documents or whatever, I just use my laserjet now. I've been
tempted to see if I can get the R200 drivers to work under Wine. I've
never had much luck with Wine, though. Maybe I should get a little more
serious about playing with it...
-----------------------------------------------------------------------
This list is provided as an unmoderated internet service by Networked
Knowledge Systems (NKS). Views and opinions expressed in messages
posted are those of the author and do not necessarily reflect the
official policy or position of NKS or any of its employees.
This archive was generated by hypermail 2.1.3 : Fri Aug 01 2014 - 19:56:31 EDT