>> Now I get nothing from the keyboard or mouse (the keyboard works in the
BIOS, so it and the PS/2 controller work at least somewhat)
It's a long shot, but... You might want to remove, then reinstall the mouse
and keyboard connectors. Since you didn't do anything (that you know
about), you should do that just to rule out it out.
Otherwise, I suspect either a trace cracked, or you have a "new" short. The
act of removing/replacing the power connectors can cause a board to flex, or
shift position. I had one board that worked on the bench, but failed on the
desk. I felt pretty stupid when I heard/found the loose screw I dropped.
Ken Elliott
=====================
-----Original Message-----
From: slug@nks.net [mailto:slug@nks.net] On Behalf Of eben1@tampabay.rr.com
Sent: Thursday, December 29, 2005 4:30 PM
To: slug@nks.net
Subject: [SLUG] no input from keyboard and mouse
Hey. I just tried to change my power supply and failed (candidate was
dead), so I ut the old one back in. Now I get nothing from the keyboard or
mouse (the keyboard works in the BIOS, so it and the PS/2 controller work at
least somewhat).
I checked in X and in console. What should I examine? There are other
machines in the house (I'm using one now), but of coutse I'd like that one
back.
Thanks.
-----------------------------------------------------------------------
This list is provided as an unmoderated internet service by Networked
Knowledge Systems (NKS). Views and opinions expressed in messages posted
are those of the author and do not necessarily reflect the official policy
or position of NKS or any of its employees.
-----------------------------------------------------------------------
This list is provided as an unmoderated internet service by Networked
Knowledge Systems (NKS). Views and opinions expressed in messages
posted are those of the author and do not necessarily reflect the
official policy or position of NKS or any of its employees.
This archive was generated by hypermail 2.1.3 : Fri Aug 01 2014 - 20:27:07 EDT