Bryan,
I don't know how to save a session prompt window data. I ran the program and it said I have 1 pci net cart, 1 pci video card, a pci bridge etc.. Not 2 cards for pci net.
The forward_ipv4="no" line is not in the network.conf.old file that the redhat v7.1 update1 created. There are a few *.*.old files created by the update1. How can I erase
the network setup like in windows. Then maybe I can reconstruct the netcard setup. The net card is to have a fixed ip.
192.168.1.3 . The card uses dmfe.o pci driver and has no parameters passed to it.
thanks,
bob
Bryan-TheBS-Smith wrote:
> Robert Krencis wrote:
> > jeffery,
> > ifcfg-eth0 file has only one alias line for eth0
> > modules.conf has "alias eth0 dmfe" line in it
> > etc/sysconfig/ntwork
> > has:networking=yes,hostname=fqdn,gatewaydev="eth0",
> > gateway=10.0.0.100,forward_ipv4="no"
>
> Let's approach this methodically and get it done in one shot.
>
> Give me:
> 1. [the output of] "/sbin/lspci -v"
> 2. The IPs you want to use for your two interfaces,
> plus your default gateway (or let me know which are DHCP)
>
> I'm assuming you are not using an ISA NICs. If you are, you'll need
> to give me the specific board, I/O and IRQ info.
>
> -- TheBS
>
> --
> Bryan "TheBS" Smith mailto:b.j.smith@ieee.org chat:thebs413
> Engineer AbsoluteValue Systems, Inc. http://www.linux-wlan.org
> President SmithConcepts, Inc. http://www.SmithConcepts.com
This archive was generated by hypermail 2.1.3 : Fri Aug 01 2014 - 20:01:18 EDT